The explanation isn't really that relevant so you don't really have to read this.
Just to avoid being called stupid in every comment on this thread, I want to preface this post by explaining that the reason why I want to use SilentAura instead of AA + Auto is because whenever I would try to mine a block in bedwars, it sometimes pops right back after it's mined. However, this only happens when I hold down my left click to autoclick the air (not mining anything) then switch my aim to look at the block. But if I only start clicking when I am looking at the block, it mines perfectly fine. I think it might have something to do with the fact that Hypixel doesn't always register the block break properly because I was clicking right before I started mining and then it got confused or something I dunno?? I've missed so many beds and gotten blocked on bridges so many times in bedwars because of that and I'm starting to get tired of it.
To fix this block break cancelling glitch, I could either use the trigger mode on Autoclicker so I don't start autoclicking before my aim goes on the block, or I could use SilentAura, which doesn't click unless there is a target in range. The problem with trigger mode is that it doesn't start clicking until an enemy is within 3 blocks, which renders reach useless.
Just to avoid being called stupid in every comment on this thread, I want to preface this post by explaining that the reason why I want to use SilentAura instead of AA + Auto is because whenever I would try to mine a block in bedwars, it sometimes pops right back after it's mined. However, this only happens when I hold down my left click to autoclick the air (not mining anything) then switch my aim to look at the block. But if I only start clicking when I am looking at the block, it mines perfectly fine. I think it might have something to do with the fact that Hypixel doesn't always register the block break properly because I was clicking right before I started mining and then it got confused or something I dunno?? I've missed so many beds and gotten blocked on bridges so many times in bedwars because of that and I'm starting to get tired of it.
To fix this block break cancelling glitch, I could either use the trigger mode on Autoclicker so I don't start autoclicking before my aim goes on the block, or I could use SilentAura, which doesn't click unless there is a target in range. The problem with trigger mode is that it doesn't start clicking until an enemy is within 3 blocks, which renders reach useless.
I need a main-safe config for SilentAura that bypasses wd and doesn't get staffed. I did some testing (see settings in attached image) and I set both the Aim speed and Max angle pretty low so it's basically impossible to notice the weird head movements (I also have AA turned on to help with the low aim speed on SilentAura). I just wanted to double-check here- are the settings in the attached image safe on Hypixel?
Another thing I noticed is that the Attack range setting in SilentAura overrides the Reach setting, but, unlike reach, it doesn't have a range of reach values. My second question is, does setting the Attack range to 3.2 still flag, even silently? I'm fine with lowering it slightly to 3.15, maybe even 3.1, but probably not more than that. If 3.1 Attack range does flag, I'll probably just go back to Autoclicker.
Any advice is appreciated, thanks!